Sewing the Trick or Treat Sack
Are you ready to sew up your very own Halloween bag? Well let’s get sewing.
Note: All seam allowances are ½” unless otherwise specified.
First you will need to cut your fabric.
I used 2 fabrics, the apothecary jars and the dots.
From the Apothecary jars I cut:
2 rectangles 15” x 4”
2 rectangles 15” x 18”
From the dots I cut:
2 rectangles 15” X 15”
2 rectangles 17” X 5”
From a mid weight fusible interfacing cut”
2 rectangles 15” X 18”
2 rectangles 17” x 5”
Now that you have rotary cut all the fabric you are ready to get sewing. Start by laying the smaller apothecary strip on the dot square piece with right sides together. Line up the 15” edge, pin and sew. Repeat for the other side.
Fold the apothecary strips up and press the seams flat.
Fuse the interfacing to the back of both pieces.
To create the Black Death Brew label I got onto Martha Stewart’s website and found a label I liked. I used Photoshop to adjust the size and customize it a bit. Once I was satisfied, I printed it onto the photo fabric that goes right through the machine. This is cool stuff, and if you don’t have any already, you should probably rush over to Stitchology and get some. (Only don’t rush too fast because it has been backordered for a bit and we are all out).
Trim around the label you printed, place it on the bag where you want and sew around the edges. I chose to leave the edges raw to give it a spookier look.
Once you have applied the label, lay the pieces together with right sides together. Pin and sew the 2 sides and bottom edge of the bag.
Clip your corners so things will turn nice and clean.
Turn the bag right side out. It should be looking purty snazzy at this point.
Now you are ready to sew the lining of the bag. To do this, put your two larger apothecary rectangles together with right sides together. You will sew the sides and bottom, but this time you need to leave an opening to turn the bag through so leave about 5” open in the bottom.
Now we will move onto the handles.
Start by fusing the smaller interfacing rectangle to the wrong side of the smaller dot rectangle.
Fold them in half (with wrong sides together) lengthwise. Press.
Open the fold up, and fold one edge to the center crease and press.
Repeat for the other edge so both sides meet up in the middle.
Fold in half again and press. Edge stitch both long sides to keep everything in place. Repeat for second handle.
To attach the handles, place them to the wrong side of the bag where you want them. Make sure they are laying the same direction as in my picture, and that they line up on both sides of the bag.
Baste in place.
Slide the bag into the lining so that right sides are together.
Match up the top edges and pin in place. In a perfect world your seams will line up. If they do not, go ahead and gently stretch the layors to fit.
Sew around the top edge.
Now you can pull the bag out of the lining through the hole we left in the step above.
Sew up the hole in the lining and push the lining to the inside of the bag. If you like, edge stitch around the top of the bag to help everything stay in place.
And there you have it: A truly terrifying Halloween bag that everyone will be envious of!